Applications often require rugged terminals and lower mating force to reduce operator fatigue during assembly and/or to withstand high-mating cycles. The pre-lubricated version can be mated up to 250 times and fit into standard Micro-Fit 3.0 Housings. Micro-Fit 3.0 RMF (Reduced Mating Force) Terminals are designed for applications needing lower engagement and disengagement forces or when the units are cycled frequently. 0766500013 Connector Kit Rectangular - Contact, Header, Housing from Molex. For lower applied costs, OEMs often prefer a compliant pin connector over one that requires soldering. The Micro-Fit 3.0 CPI Header mates with Micro-Fit 3.0 Receptacle, allowing running changes as boards transition from solder to press-fit applications. The robust eye-of-the-needle design provides a reliable interface when recommended board layouts are followed. Micro-Fit 3.0 CPI (Compliant Pin) Connectors provide a compliant pin interface while maintaining all the features of the standard Micro-Fit 3.0 Connector. The TPA reduces terminal back-out by providing locking redundancy assemblers cannot insert the TPA unless terminal is properly inserted. The Micro-Fit TPA Connector Family helps prevent failure in end products by offering terminal position assurance (TPA). Doing so can cause damage to the connector and/or terminal and consume valuable labor time. In hard-to-reach applications, such as drawers or fan assembly trays, connectors need to be mated and unmated without being seen. They allow mating misalignment (per product drawing). Micro-Fit 3.0 Blind-Mate Interface (BMI) Connectors are designed for blind-mating applications. OEMs often need power connectors in space-constrained applications. In the years that have followed Eisenbarth and Armstrong have quietly guided CSI into a strong presence in many forms of motor sports.The Micro-Fit Connector Family offers up to 8.5A with a 3.00mm pitch, delivering power in a compact package in wire-to-wire and wire-to-board configurations. The continued success of Racepak has allowed CSI to grow. That challenge became the initial goal that led to the formation of Competition Systems, Inc. Das Micro-Fit 3.0-System von Molex ist ein einzigartiges Verbindungssystem, das speziell zur Bereitstellung von Signal- bzw. Their respective backgrounds qualified them to develop such equipment, but the major task that needed to be overcome was in designing and building a data recorder that could survive in the unfriendly world of race vehicles. Through an earlier joint effort aimed at obtaining data for the improvement of the Unlimited Hydroplane that Armstrong was piloting at the time, both men realized the need for onboard data acquisition equipment. Both men were engineers with strong backgrounds in electrical and mechanical applications, and both had an interest in motor sports. Racepak LLC was founded in 1984 by Spencer Eisenbarth and Ron Armstrong, originally as Racepak and its parent company, Competition Systems, Incorporated (CSI). As a leading global provider of connector solutions, Molex brings engineering excellence, trusted relationships, and an unparalleled commitment to quality and reliability to help customers across industries improve lives. Includes both male and female connectors, extra pins and sockets and heatshrink. Molex believes in the transformative power of creating connections. This replacement connector can repair a damaged cable, V-Net module or sensor that connects to our Molex 3-pin connectors.
0 Comments
Leave a Reply. |